Tapered Graphite Wedge Block For Self Supporting Kiln Stacks

Send Inquiry
Tapered Graphite Wedge Block For Self Supporting Kiln Stacks
Details
Tapered Graphite Wedge Block for Stable Self Supporting Stacks Product Overview The tapered wedge block is cut with two faces meeting at a shallow angle instead of parallel faces. Placed between flat blocks in a kiln or furnace stack, the wedge takes up the natural unevenness of a load and stops...
Category
Graphite Block
Share to
Description

Tapered Graphite Wedge Block for Stable Self Supporting Stacks

Product Overview

The tapered wedge block is cut with two faces meeting at a shallow angle instead of parallel faces. Placed between flat blocks in a kiln or furnace stack, the wedge takes up the natural unevenness of a load and stops the stack from rocking, so heavy charges stay stable through heating and cooling.

Because the angle is machined rather than packed with shims, the support is solid and repeatable. Wedges can be paired to form a parallel seat or used singly to correct a lean, and the broad faces spread the load over a large area.

Jincheng cuts the wedge angle to the stack requirement and produces the blocks from a strong, medium-grain class that resists crushing at the contact line.

tapered graphite wedge block for kiln stacks

Key Features and Design Details

  • Controlled wedge angle corrects uneven seating
  • Broad load faces spread weight over a large area
  • Solid one-piece form replaces loose packing
  • Crush-resistant class holds the contact line
  • Pairable into a parallel seat
  • Custom angle, height, and base size

Technical Specifications

Form rectangular block with tapered faces
Density 1.68 - 1.80 g/cm3
Wedge angle 1 - 12 degrees, custom
Base size 80 - 350 mm
Height range 50 - 300 mm
Compressive strength 70 - 130 MPa
Bending strength 32 - 55 MPa
Hardness 46 - 66 HSD
Heat conductivity 75 - 130 W/m·K
Porosity 10% - 14%
Temperature limit up to 2800 deg;C in vacuum
Angle tolerance +/-0.1 degree

Applications and How to Use

The blocks are used under saggars, boats, and stacked charges in kilns and heat-treatment furnaces. Place the broad face on a flat support and use the taper to level the load, checking the stack for movement before heating.

Inspect the contact edges after each cycle and replace any wedge that has chipped, since a damaged edge concentrates the load.

Material Grade Selection and Quality Control

A medium-grain, high-compressive-strength class is chosen so the thin end of the wedge does not crush under load. Each block is checked for angle, base dimensions, and edge condition before packing.

Why Choose Jincheng

  • Wedge angle made to the stack drawing
  • Solid support instead of loose shims
  • High compressive strength for heavy charges
  • Consistent dimensions for repeatable stacking
  • Direct factory supply with clear lead times

Frequently Asked Questions

Can the angle be customised?

Yes, the taper is cut to the angle required by the stack.

Why use a wedge instead of shims?

A solid wedge cannot slip or crumble like loose packing, so the stack stays stable.

Can two wedges form a flat seat?

Pairing two opposed wedges gives a parallel support of adjustable height.

How much load can they carry?

The high-compressive class carries heavy kiln charges when the load is spread over the broad face.

Hot Tags: tapered graphite wedge block for self supporting kiln stacks, China tapered graphite wedge block for self supporting kiln stacks manufacturers, suppliers, factory, graphite block blank, graphite block chemical industry use, graphite block for arc furnace system, graphite block for ceramic industry, high density graphite block, molded graphite block

Send Inquiry