Double End Threaded Graphite Rod For Column Assembly

Send Inquiry
Double End Threaded Graphite Rod For Column Assembly
Details
Double End Threaded Graphite Rod for Structural Column Assembly Product Overview The double end threaded rod carries external threads at both ends with a plain section between them. It works as a tie member that pulls two graphite plates or frames together, replacing metal tie rods inside hot...
Category
Graphite Rod
Share to
Description

Double End Threaded Graphite Rod for Structural Column Assembly

Product Overview

The double end threaded rod carries external threads at both ends with a plain section between them. It works as a tie member that pulls two graphite plates or frames together, replacing metal tie rods inside hot zones.

The plain middle section keeps the rod's full strength where bending is highest, while the threaded ends provide the clamping connection. Because the whole rod is graphite, the assembly expands at a similar rate to the parts it joins, so the clamping force stays stable through heating.

Jincheng cuts the threads to the required size and produces the rod from a dense, high-purity class.

double end threaded graphite rods

Key Features and Design Details

  • Threads at both ends for tie connections
  • Plain centre section retains bending strength
  • Matched expansion keeps clamping force stable
  • All-graphite assembly without metal tie rods
  • Pairs with graphite nuts
  • Custom thread size and rod length

Technical Specifications

Form rod threaded at both ends
Density 1.76 - 1.86 g/cm3
Rod diameter 10 - 60 mm
Overall length 100 - 600 mm
Thread M8 - M48 or custom
Resistivity 8 - 13 micro;ohm·m
Bending strength 40 - 60 MPa
Hardness 50 - 70 HSD
Heat conductivity 95 - 145 W/m·K
Ash content below 0.1%
Thread tolerance +/-0.03 mm
Surface Ra 1.6 microm

Applications and How to Use

The rod is used to clamp hot-zone frames, plate stacks, and structural columns. Thread a nut onto each end and tighten evenly so the joint is pulled together without bending the rod.

Inspect the threads between assemblies and replace the rod if any thread is chipped or cracked.

Material Grade Selection and Quality Control

A dense, high-purity class is used so the threads hold and the rod stays strong. Each rod is checked for thread fit, straightness, and length before packing.

Why Choose Jincheng

  • Tie connections without metal hardware
  • Stable clamping through thermal cycles
  • Strong plain centre section
  • Custom threads and lengths
  • Direct factory supply with clear lead times

Frequently Asked Questions

Can the threads match existing nuts?

Yes, the thread size is cut to the required specification.

Why is the centre left plain?

The unthreaded section keeps full strength where bending is highest.

Does clamping force change with temperature?

Matched expansion with the joined graphite parts keeps it stable.

What nuts are used?

Graphite nuts are used to keep the whole assembly metal-free.

Hot Tags: double end threaded graphite rod for column assembly, China double end threaded graphite rod for column assembly manufacturers, suppliers, factory, graphite bar, graphite rod blank material, graphite rod electrical conductivity, graphite rod electrolysis use, graphite stirring rod, high thermal conductivity rod

Send Inquiry