Graphite Induction Brazing Ring For Coil Concentrators

Send Inquiry
Graphite Induction Brazing Ring For Coil Concentrators
Details
Graphite Induction Brazing Ring For Coil Concentrators An induction coil heats a small joint unevenly unless a concentrator focuses the field. A graphite ring placed around the joint absorbs the field and re-radiates heat into the part, which evens the temperature around the braze line. The ring...
Category
Graphite Ring
Share to
Description

Graphite Induction Brazing Ring For Coil Concentrators

Graphite Induction Brazing Ring For Coil Concentrators

An induction coil heats a small joint unevenly unless a concentrator focuses the field. A graphite ring placed around the joint absorbs the field and re-radiates heat into the part, which evens the temperature around the braze line.

The ring is sized from the joint diameter and the coil position, and its wall thickness sets how quickly it reaches temperature. Because graphite does not react with the braze alloy, any accidental contact leaves no contamination on the part.

Key Features

  • Field concentration - the ring couples with the coil and re-radiates into the joint

  • Even circumferential heating - wall section is uniform so the braze line heats evenly

  • Non-contaminating - no alloy pickup if the ring touches the part

  • Fast response - low thermal mass reaches brazing temperature quickly

  • Replaceable wear part - rings are consumables and are priced accordingly

  • Custom diameters - bore and height matched to the joint and coil

Technical Specifications

Property Typical Value
Grade fine-grain, high purity
Density 1.85 - 1.92 g/cm3
Resistivity 8 - 14 microohm.m
Ash content below 0.05 percent
Inner diameter 10 - 120 mm
Outer diameter 20 - 160 mm
Height 8 - 60 mm
Wall thickness 4 - 20 mm
Concentricity 0.10 mm
Service temperature 900 C in air, higher in inert gas
Coil clearance 2 - 8 mm
Supply form single ring or matched set

Applications & How to Use

Induction brazing of carbide tips

the ring evens the braze line around the tip

Pipe joint brazing

a ring concentrator heats the joint without a large coil

Diamond segment joining

even heating limits segment shift during the braze

Repair brazing stations

small rings fit hand-held induction tools

Replacement of machined concentrators

the ring is cheaper to replace than a coil insert

Why Choose Jincheng

  • Bores are machined concentric with the outer diameter, so the field stays symmetric
  • Wall thickness is agreed from the required heat-up time
  • High-purity grade keeps the joint free of contamination if contact occurs
  • Rings are small consumables, so a spare set can be held on the bench
  • Matched sets keep several stations behaving the same way
  • Custom diameters are cut for joints outside the standard range

FAQ

Does the ring get hot itself

Yes, that is how it works: it couples with the field and re-radiates heat into the joint, which evens the braze line

How close should the coil be

Typically 2 to 8 mm from the ring, depending on the coil and the power supply

Can it be used in air

Yes, up to about 900 C; above that an inert or reducing atmosphere is needed

Is it a consumable

It is treated as a wear part, because repeated cycling gradually oxidises the surface

Related Graphite Products

Graphite Brazing Boat

Graphite Brazing Fixture Plate

Graphite Grade Selection Checklist

Hot Tags: graphite induction brazing ring for coil concentrators, China graphite induction brazing ring for coil concentrators manufacturers, suppliers, factory, graphite ring for boiler system, graphite ring for engine sealing, graphite ring for industrial automation, graphite ring for vacuum pump, graphite sealing rings, molded graphite ring

Send Inquiry