How To Set Up A Graphite Mold For Continuous Ingot Casting

Nov 13, 2026

Leave a message

Sophia Miller
Sophia Miller
Sophia is a logistics coordinator at the factory. She is good at arranging the transportation of products, ensuring that they can be delivered to customers in a timely manner, whether in China or overseas.

Setting Up the Mold

Continuous ingot casting depends on a mold that is clean, correctly aligned, and preheated to a stable temperature. The graphite mold defines the ingot profile and must be mounted so the solidifying metal moves through it without binding or leakage.

Misalignment or unstable temperature causes surface defects, sticking, and inconsistent ingot dimensions.

Key Operating Steps

Preheat the dry mold to the recommended range, confirm the cooling and withdrawal setup, and feed metal at a controlled rate that matches solidification. Keep the working surfaces smooth and clean, since graphite's non-wetting behavior relies on an undamaged surface.

Monitor the first sections of each run closely, because early adjustments to temperature and withdrawal speed stabilize the whole cast.

Maintenance and Troubleshooting

Inspect the mold between runs for wear, scoring, and cracking, and replace sections that no longer produce the required surface. Avoid thermal shock and never introduce damp material into the hot system.

Keeping a setup record of temperature, feed rate, and results makes each subsequent run faster to stabilize.

Conclusion

A clean, aligned, preheated graphite mold is the foundation of consistent continuous ingot casting. Stable temperature and controlled withdrawal, backed by regular inspection, keep ingot quality repeatable.

Send Inquiry